Desa 30LP Uživatelský manuál Strana 1

GENERAL HAZARD WARNING: FAILURE TO COMPLY WITH THE PRECAU-TIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN RESULT INDEATH, SERIOUS BODILY INJURY

10104163PROPANE CONSTRUCTION HEATER30,000 BTU/HrIGNITOR1. Remove motor and fan guard from heater(see Motor, page 8, steps 1 and 2).2. Remove black ign

11104163OWNER’S MANUALACCESSORIESPurchase accessories and parts from yournearest dealer or service center. If they cannot supply an accessory or part,

12104163PROPANE CONSTRUCTION HEATER30,000 BTU/HrILLUSTRATEDPARTSBREAKDOWNBLP30RLP30REM30LP20291017113221215519181378416211461

13104163OWNER’S MANUALPARTS LISTBLP30RLP30REM30LPThis list contains replaceable parts used in your heater. When ordering parts, follow theinstructions

WARRANTY AND REPAIR SERVICELIMITED WARRANTYKEEP THIS WARRANTYFor information, write: DESA International, P.O. Box 90004Bowling Green, Kentucky 42102-9

2104163PROPANE CONSTRUCTION HEATER30,000 BTU/HrSAFETYINFORMATION WARNING: FIRE, BURN, IN-HALATION, AND EXPLOSIONHAZARD. KEEP SOLID COMBUS-TIBLES, SUC

3104163OWNER’S MANUALAir For Combustion Air For HeatingPRODUCTIDENTIFICATIONFigure 1 - 30,000 BTU/Hr ModelUNPACKING1. Remove all packing items applie

4104163PROPANE CONSTRUCTION HEATER30,000 BTU/HrINSTALLATION WARNING: Review and un-derstand the warnings in theSafety Information section, page2. They

5104163OWNER’S MANUALVENTILATION WARNING: Provide at least aone square foot opening of fresh,outside air while running heater.If proper fresh, outside

6104163PROPANE CONSTRUCTION HEATER30,000 BTU/HrSTORAGE1. Store propane tank(s) in safe manner.See Chapter 5 of Standard for Storageand Handling of Liq

7104163OWNER’S MANUALTROUBLESHOOTING1. Check voltage to electrical outlet. If volt-age is good, check heater power cord forbreaks2. Adjust motor/fan g

8104163PROPANE CONSTRUCTION HEATER30,000 BTU/HrSERVICEPROCEDURES WARNING: Never serviceheater while it is plugged in, con-nected to propane supply, op

9104163OWNER’S MANUALFAN1. Remove three screws that attach fanguard to heater shell.2. Remove motor and fan guard fromheater shell (see Figure 13).3.